Full Dimensional Inspection Machine for Engine Valve
1. Processing range (the original state of the workpiece):
Workpiece status |
Processing conditions |
Remarks |
Valve head diameter |
MAX Φ40mm |
|
Stem diameter |
φ5~12㎜ |
|
Length |
80~250㎜ |
|
Material quality |
21-4N+4Cr10Si2Mo |
|
Hardness |
30—60HRc |
|
Workpiece Surface |
Clean without debris |
|
Testing Angle Range |
unlimited |
|
Testing Environment Humidity |
Below 85%RH |
No condensation |
Testing Environment Temperature |
0~45℃ |
|
2. Processing accuracy and cycle time:
Contents |
Accuracy |
Test methods and tools |
Angle Types: C-face angle, cone projection angle, etc. |
Continuously test and measure 50 pieces within ±0.1°. |
Special measuring tool |
Measuring Position Types: Distance from defects (defects, foreign objects), main control contour comparison, etc. |
Continuously test and measure 50 pieces within ±1μm. |
Calipers, micrometers |
Diameter Tolerance Types: Large end face diameter, stem diameter, groove diameter, R-angle diameter, etc. |
Continuously test and measure 50 pieces within ±1μm. |
Calipers, micrometers |
Geometric Tolerance Types: True roundness, straightness, run-out accuracy, concentricity, etc. |
Continuously test and measure 50 pieces within ±1μm. |
Projector |
Vibration Types (Taking 6 points): Cone vibration, shaft vibration, etc. |
Continuously process and measure 50 pieces within ±3μm. |
Contact-type μ-meter |
Inspection Efficiency (Cycle Time) |
Standard 7.5s/pc for the inspection of the valve head and the run-out, plus the tip end without the run-out. |